A furnace that starts, then refuses to stay on

Repeated start attempts need a cause, not a succession of resets. Keep the cabinet closed and keep the message or sequence you already noticed.

Safety first. Gas odor or a suspected leak: leave immediately without using switches, flames or a phone in the affected area. From safety, call 911 and your gas supplier. For a carbon monoxide alarm or suspected exposure, get outside and call 911.

Call Now (772) 264-9585

Confirm the address, equipment, accepted repair and availability.

Does an ignition code mean the igniter is the failed part?

A code reports what the control detected. The cause can involve the ignition sequence, flame detection or another operating condition. Ask for the confirming test before agreeing to a named part. This guide applies to fuel-burning furnaces, not electric resistance heaters.

Keep the sequence you already observed

Tell us whether the furnace stayed silent, made a short start attempt or produced warmth before stopping. Copy an alert from the normal control screen or a designated viewing window only when it is safely accessible. Do not remove a door to watch ignition.

Avoid cycling the power to obtain a different code. Do not relight equipment, clean a sensor or hold a door switch closed based on general internet instructions. The correct procedure depends on the model and the reason for the stop.

Treat a stop as a warning

A fuel-burning furnace uses operating and safety controls during a heating cycle. An unsuccessful start and a shutdown after sustained heating are different events. That distinction helps frame the check without claiming either is safe.

A restriction in airflow can be associated with overheating and shutdown. Ignition faults can also interrupt heating. Neither possibility can be selected from a brief sound or a thermostat message alone.

Keep fuel and vent work explicit

Use an old bill, manual or service record to name the fuel if known. A Fort Pierce mailing address does not prove that a home has natural gas.

Ask whether the work stays inside the furnace or changes fuel pipes, vents or the air supply for the burner. Confirm who is qualified for that work. A utility gas supply and a private furnace repair are separate tasks.

Approve the finding, then the remedy

Request the observed failure, the test that supported it and the repair needed to address it. If replacement is planned because operation is unsafe, ask for the finding and its limits in writing. Do not restart equipment that has been declared unsafe while seeking another opinion.

Tell us how to enter, who can approve work and what blocks access to the cabinet or vent. Do not climb a ladder, go onto a roof or enter a tight space to prepare for a call.

Questions about this repair

Can a furnace briefly warm the house and still have a fault?

Yes. A brief heating period does not establish reliable or safe operation. Report when warmth stops and any alert that remains.

Is the repair number an emergency gas line?

No. A suspected leak, fire or carbon monoxide emergency needs 911 and the proper utility from a safe location. Arrange equipment service after emergency instructions allow it.

Sources for this guidance
fpua.com U.S. Consumer Product Safety Commission Carrier heating guidance Carrier heating guidance